Grass Valley T2 Classic iDDR AMP Remote Control SP4.3 - Manual (Page 7)

October 17, 2011 T2 Users Manual –AMP Remote Control– 7
T2 Control from external device (P1/P2-Remote mode)
T2 Control from external device (P1/P2-Remote mode)
P1/P2-Remote mode controls the P1/P2 channel of T2 from an external controller. T2
accepts commands from the external controller as a device (slave).
If you use AMP commands in the P1/P2-Remote mode, connect T2 and an external
controller via Ethernet, and then configure T2 by the following procedure.
NOTE: For the available AMP commands in the P1/P2-Remote mode, see "AMP
commands" on page 9 .
Configuration for using AMP commands
This section describes the procedure in which a user operates T2 in the workstation
mode. The same procedure applies to the operation in the front panel mode.
1. Start up T2 in the normal mode.
2. Click Config.
3. Click Monitor & Remote in the "P1" or "P2" tree.