Amp commands – Grass Valley T2 Classic iDDR AMP Remote Control SP4.3 User Manual
Page 11
October 17, 2011
T2 Users Manual –AMP Remote Control–
11
AMP commands
*1 Operates only when the specified speed is 0 (Stop).
*2 Supported status flag
41.42
Set Loop
Playback
Mode
No
No
○
○
○
If you want to change the setting during
playback, send the command approximately
four seconds or more before it comes to the
position to set loop.
41.43
Set
Widescreen
Mode
No
○
No
No
No
41.44
Set Stop
Mode
No
No
○
○
○
If you want to change the setting during
playback, send the command approximately
four seconds or more before it comes to the
position to set stop.
40.45
Get Stop
Mode
No
No
○
○
○
60.0B
State
Change
Latency
Request
No
No
No
No
No
Not supported on T2.
61.0C
Current
Time Sense
○
○
○
○
○
Since obtaining User Bits is not supported,
00000000 will always be returned.
The response is always the same value
regardless of the type of LTC or VITC.
If LTC source or VITC source has been
specified, R1 input timecode is returned.
1:LTC, 4:Timer, 8:WindowsTime, 40:LTC
(Src) (LTC input of R1) are only supported.
61.20 Status Sense
*2
○
○
○
○
○
AX.02
Record Cue
Up With
Data
No
○
No
No
No
Only specifying the clip name is available.
Data0
Busy, Remote+Local, Local
Data1
Play, Record, FFW, REW, Stop
Data2
Still, TapeDirection, Var, Shuttle
Data3
InPreset, OutPreset, AutoMode, FolderalreadyExist, InvalidFolderName,
FolderDeletionFail, SourceMissing
Data4
EEOn, LoopPlayBack
Data9
FolderNotFound, OutPresetFail, PreviewInPreset, PreviewOutPreset
DataA
IDNotFound, MovieDeleteComplete, MovieDeleteFail
DataD
TapeTop, TapeEnd, LTC, Timer, VITC, TimeOfDay, DropFrame
Command
Channel-
less
mode
R1
P1/P2
Normal
mode
3D
Sync
mode
Fill/Key
mode
Supplementary note on T2 operation