Grass Valley Profile Analog Composite Monitor - Manual (Page 9)

Analog Composite Monitor Installation 9
Monitor Board Installation
Introduction
Use these instructions to install the Analog Composite Monitor board into a
PDR 100 Video Disk Recorder or PDR 200 Video File Server. The Monitor board
provides four channels of analog composite video output with Time-code burn-in
and text overlay. With this board you can simultaneously display independent time
codes of the four playback channels on a picture monitor display. Each channel
also provides text overlay for source identification.
The instructions include procedures for opening the Profile chassis, removing
existing boards (if necessary) to make room for the new board, installing the new
board, closing the Profile chassis, and verifying that the board is correctly
installed.
You can install the board with the Profile chassis fully extended on the rack slides
if the equipment rack is adequately mounted to prevent tipping, and if there is
sufficient slack in the cables connected to the rear panel to allow the chassis to fully
extend on the slides.
If it is necessary for you to remove the Profile chassis from the equipment rack to
perform this installation, refer to the Profile system’s Installation Manual for
instructions.
WARNING: Unless the equipment rack is adequately anchored, the rack
could tip when the chassis is extended on the rack slides. To avoid possible
injury, make sure the rack is firmly anchored before extending the chassis on
the rack slides.
!