Grass Valley Profile Analog Composite Monitor - Manual (Page 24)

Monitor Board Installation
24 Analog Composite Monitor Installation
2. From the Board I/O Requirements and Restrictions table, note that the
Analog Composite Monitor board requires four inputs and no outputs and
that the recommended slot is J12, with J6 and J7 as other possible slots.
3. Looking at your Board Location Chart, you see that the recommended slot,
J12, is open.
4. On your Board Location Chart:
- Put Xs in the J12 Input blocks 1-3.
- Put an X the shared J13 input block.
5. Write Analog Composite Monitor in the Boards column for slot J12 and
install the board.
Your Board Location Chart would then look similar to Table 3: Example 1.