Grass Valley Profile Analog Composite Monitor - Manual (Page 35)

Installing the Monitor Board
Analog Composite Monitor Installation 35
4. Install the blank circuit board brackets (if necessary) in the empty board slots
on the rear panel.
5. Refer to “Audio Clock Cabling” beginning on page 20 and reconnect any
audio clock cables previously removed.
6. Use the Torx tool with the T10 tip to reinstall the rear board hold-down
bracket (see Figure 2, page 7).
CAUTION: To prevent damage to the Monitor board, a short board extension
on the front hold-down bracket must not be installed at the Monitor board
location.
7. If necessary, reconfigure the front board hold-down, moving or removing a
short board extension and use the Torx tool with the T10 tip to reinstall the
front board hold-down bracket (see Figure 2, page 7).
8. Use the Torx tool with the T10 tip to reinstall the rear top cover with the
screws previously removed.
9. Use the Torx tool with the T10 and T15 tips to reinstall the front top cover
with the screws previously removed.
10. Apply the stick-on label at the appropriate location in the Profile chassis rear
panel to identify the location of the Analog Composite Monitor board and
any board you repositioned.
11. Reinstall the Profile chassis in the rack and reconnect all cables previously
removed. Before attaching cables to the BNC connectors, install the mesh
washers as shown in Figure 8.
Figure 8. Installing Mesh Washers
!