Grass Valley Profile Analog Composite Monitor - Manual (Page 36)

Monitor Board Installation
36 Analog Composite Monitor Installation
12. Install mesh washers (Figure 8) and connect analog composite output cables
to the Analog Composite Monitor board. See Figure 9 for an example
Figure 9. Analog Composite Monitor Board Cable Connections
13. Apply power to the Profile system and start the Profile Configuration
Manager application. Check the graphic representation of the Profile rear
panel. It should indicate the presence of the Analog Composite Monitor
board in slot J12 where you installed the board.
14. Configure the system for the Analog Composite Monitor board as instructed
in the Profile Family User Manual.
J1 J17 J13 J16 J15 J14 J6 J7 J4 J3 J2 J5 J12 J11 J9 J8 J10
0043-1
Out B
Out A
Out C
Out D
Video Out
Analog Composite (Monitor)