Grass Valley MPEG Upgrade - Manual (Page 44)

MPEG Board Upgrade Installation
34 MPEG Board Upgrade Installation
Table 7. Board I/O requirements and restrictions for an MPEG-ready PDR200
Board Video Router
Connection
Requirements
Recommended
Slots Other
Possible
Slots Comments
Inputs Outputs
CPU n/a n/a J1 None Reserved for PC card only
VGA n/a n/a J2 None ISA only
LAN n/a n/a J3 None EISA only
SCSI n/a n/a J4 None EISA only
RefGen n/a n/a J16 None Reference genlock
RS-422 n/a n/a J17 None EISA only
Master EDR 2 2 J10 None Must be adjacent to Slave EDR and Fibre
Channel (if installed). PCI Interconnect
required.
Slave EDR 2 2 J11 None Must be adjacent to Master EDR and
MPEG (if installed). PCI Interconnect
required.
Analog
Composite In None 1 J14 J15, J7 Must be adjacent to the Analog Composite
Decoder
Analog
Composite
Decoder None None J13 J14, J6 Must be adjacent to Analog Composite In
Four Channel
Analog Out 4 None J6 J7
Analog
Composite I/O 2 2 J14, J15 J6, J7, J13
Analog
Composite
Monitor Out 4 None J6 J7
Serial Digital I/O 2 2 J14, J15 J6, J7, J13 Cables must be able to reach ASPBs
CAV In None 1 J6 J7, J13,
J14, J15
MPEG encoder 1 2 J8, J12 None Must be adjacent to either Slave EDR or
Fibre Channel (if installed). PCI
Interconnect required.
MPEG decoder None 4 J12, J8 None Must be adjacent to either Slave EDR or
Fibre Channel (if installed). PCI
Interconnect required.
Fibre Channel None None J9 None Must be adjacent to Master EDR. PCI
Interconnect required.
Mix Effects 6 2 J6 J7 Only J6 and J7 have 5 inputs; board must
be able to get a shared input (the 6th) from
an adjacent slot (J5 or J8)
Audio Signal
Processing
Board (ASPB) None None J5 (1st)
J7 (2nd)
J6, J13,
J14, J15
Cables must be able to reach video boards
or additional ASPB. Second ASPB
necessary for 32 channels of audio.