Grass Valley MPEG Upgrade - Manual (Page 20)

MPEG Board Upgrade Installation
10 MPEG Board Upgrade Installation
Removing the Circuit Board Hold-down Brackets
There are two hold-down brackets located in the circuit board area of the chassis
that must be removed in order to install other boards.
To remove the board hold-down brackets:
1. Use the Torx tool with the T10 tip to remove the exterior screw (
Ê
in
Figure 2) that secures the rear board hold-down bracket.
2. Lift the bracket (
Ë
in Figure 2) up and out of the chassis and set it aside.
3. Use the Torx tool with the T10 tip to remove the interior screw (
Ì
in
Figure 2) that secures the front board hold-down bracket.
4. Lift the bracket ( Í in Figure 2) up and out of the chassis and set it aside.