Installing the emi gasket – Grass Valley Profile Mix Effects Upgrad 100 Fibre Channel User Manual

Page 68

PDR 100 Fibre Channel Installation

To install the EMI foam gasket:

1. Use the Torx tool with the T15 tip to remove the screws which secure the

power supply to the side of the chassis.

2. Refer to

in Figure 28 and slide the power supply toward the front of the

chassis approximately 1 inch.

3. Remove the protective strip from the adhesive on the EMI gasket.

4. Carefully slip the gasket into the chassis between the power supply and the

rear panel and attach it to the chassis just below the power cord connector
cut-out as shown at

5. Slide the power supply back into its original position and secure it to the

chassis with the screws previously removed.

Figure 28. Installing the EMI Gasket

9674-29