Example 2 – Grass Valley Profile Mix Effects Upgrad 100 Fibre Channel User Manual

Page 46

PDR 100 Fibre Channel Installation

Example 2

If you next want to install a Mix Effects board:

1. From the Board I/O Requirements and Restrictions table, note that the Mix

Effects board requires six inputs and two outputs and that the first
recommended slot is J7 with slot J6 another possibility.

2. Looking at your Board Location Chart, you see that slot J7 is occupied but

that slot J6 is open and although it only has five Inputs, the 6th Input can be
the input shared with J5, which is open.

3. On your Board Location Chart for the Mix Effects board:

- Put Xs in the 1-5 Input blocks for J6.
- Put an X in the shared Input block for J5.
- Put Xs in the 1 and 2 Output blocks for J6.

4. Write Mix Effects in the Board column for slot J6 and install the board.

• Your Board Location Chart would then look similar to Table 6, “Example 2