Grass Valley NV9607 v.1.1 - Manual (Page 57)

47
NV9607
User’s Guide
Automatic Data Routing
A take involving a machine control level occurs automatically, without intervention, regardless
of who is using a device.
This option applies in all operating modes.
Manual Data Routing
A take involving a machine control level occurs on all levels except the machine control level.
You must route the machine control level as a breakaway.
When a take involving a machine control level occurs, the status display shows the name of the
machine control level and the destination display shows “In Use.” That is a signal that you need
to take the machine control level as a breakaway.
This option applies only in single-destination mode with breakaway.
Semi-Automatic Data Routing
A take involving a source or a destination having a machine control level might not occur imme-
diately if the source or destination device is in use.
This option applies in all operating modes.
If neither device is “in use” the take occurs immediately. Otherwise, you need to press the source
button again to complete the take.
If the source device is in use, the ‘Status’ display shows “Src Used” and the destination dis-
play shows “Retry?”
If the destination device is in use, the ‘Status’ display shows “DestUsed” and the destination
display shows “Retry?”
If Both devices are in use, the ‘Status’ display shows “BothUsed” and the destination display
shows “Retry?”
If you do not press the (same) source button again, the take is canceled. (It will time out.)
Case 1 — Single-Destination Mode with or without Breakaway
1 Select a source.
2 Examine the display.
3 If the destination display shows “Retry,” press the source button again to complete the take.
The take will time out if you do not press the source button.
Case 2 — Limited X-Y Mode
1 Select a destination.
2 Select a source.
3 Examine the display.
4 If the destination display shows “Retry,” press the source button again to complete the take.
The take will time out if you do not press the source button.