Installing software and documentation, Initialization, Installation – Grass Valley NV9607 v.1.1 User Manual
Page 22
12
Installation
Installing Software and Documentation
You can also connect the panel using a serial protocol and a serial cable connected at the
panel’s DE9 port. The connection is RS-422. The system controller must have one or more
available serial ports. (The NV960 can include a serial card and a multi-port breakout box for
such a connection. There are several options available.) Refer to the NV9000-SE Utilities
User’s Guide for serial configuration options. Contact Miranda regarding serial interface
options.
3 Connect one or both power supplies. First connect the 4-pin connector to PS1 or PS2 on the
rear of the router. The connectors are keyed and snap into place. There is only one way they
fit. Do not force them. Then connect the power supply to AC power.
A second power connection is for redundancy only (protection against failure) and is not a
requirement for operation.
Refer to
on page 63 for details on the PS0001 power supply. See also
Installing Software and Documentation
This document is available through the Miranda web site.
You must use NV9000-SE Utilities to configure the NV9607 control panel. Contact Miranda if you
need to obtain the latest version of this NV9000 configuration software.
You may use the Panel IP Configuration Utility if you want to your NV9607 to have a static IP
address (with respect to the system controller) or to use DHCP. The panel, as it comes from the
factory, defaults to DHCP.
Initialization
Before your system controller can communicate with an NV9607, you must give it a panel ID.
Follow these steps for each NV9607 you are installing:
1 Power up the NV9607. Do not connect its Ethernet cable. (Disconnect it if it is connected.)
After a few seconds, the display will show ‘ACQUIRE IP ADDRESS’ at the top and show the
panel’s current panel ID. The bottom right button is high-tally green:
We call that the “setup” button while the panel is disconnected from the network.
2
1
4
3
Receptacle
n.c.
n.c.
GND
12VDC
4
3
2
1
GND
12 VDC
n.c.
n.c.
Plug
ACQUIRE IP ADDRESS
NV9607 PANEL ID 0
Setup Button