Grass Valley K2 Dyno Quick Start v.1.6 - Manual (Page 29)

13 April 2010 K2 Dyno Replay System Quick Start Guide 29
Chapter 2 Operation
• You can adjust the speed, range, and other parameters of the jog knob and the T-bar.
On the Config tab, touch
<
or
>
and then touch PLAY2 or PLAY3 to access screens
with settings.
• You can lock/unlock the controller panel (buttons, jog knob, and T-bar) to prevent
accidental operations. On the Home tab, at the bottom of the screen, touch OALOCK
(On Air Lock).
• To play an angle from the beginning of the clip, press FN and then press A or B or C .
• Swap channels between PI and P2 playout channels by pressing Fn and then Take .
• Set T-Lever control and knob speed/response in Config menu, Play-2 and Play-3 tabs.