Grass Valley iTX Ingest Appliance v.2.3 - Manual (Page 24)

12
Installation and Setup Instructions
Starting up the iTX Ingest Appliance
6 Connect the SDI Video input, SDI output and reference cables to the video card
connectors.
Fig. 2-5: Rear connections of the iTX Ingest Appliance
Starting up the iTX Ingest Appliance
Once the iTX Ingest Appliance is properly racked and connected, you can make the power
connections and perform the first-time start up of the iTX Ingest Appliance.
1 Plug the iTX Ingest Appliance’s power supply cable into a power socket.
2 Plug the VGA monitor’s power supply cable into a power socket and power on the
monitor.
3 Power on the iTX Ingest Appliance by pressing the Power button on the unit’s front
panel.
4 Observe the front panel’s Power LED to be sure that it lights up (see Overview of the
front panel components , on page 3).
Upon startup, the iTX Ingest Appliance automatically logs on as itx-user .
Note: Refer to the iTX System Administrator Guide for complete information
about the iTX software applications and service components.
5 Since the iTX Ingest Appliance and iTX software components are factory-configured
with many generic settings, you must now configure some of the Windows, system and
iTX software settings. See
Software Configuration Procedures , on page 13 for
instructions.