Grass Valley HSPARK - Manual (Page 15)

ENGLISHENGLISH
HDSPARK/HDTHUNDER - Installation Manual
Audio output (HDTHUNDER only)
Specification of audio cable (4pin-4pin) is:
Red
: Right channel (R)
White : Left channel (L)
Black : Ground (G)
For audio output, use the attached audio cable (4pin-4pin) to connect sound
device in output destination and the main board.
* Attached audio cable (4pin-4pin) branches off connectors with different
type and wiring specification. Connect the side without branch to main
board, and the side with branch to sound device in output destination. Use a
connector that complies with the connector type and wiring specification for
connecting destination. If you cannot use the attached audio cable (4pin-
4pin), prepare another cable separately.
Output from sound device on board
Connect the audio cable to the terminal of motherboard.
* Note that onboard sound device (sound device installed in motherboard:
for details, see the instruction manual for your PC or motherboard) might
interfere with the board installed in slot depending on connector position of
the device.
Output from sound board
Connect the audio cable to the terminal of sound board.
Setting the Main Board
Audio cable (4pin-4pin)
HDSP-TH_Install_EN.indd 9 10/31/2008 12:44:02 PM