Electrolux EKC5045 - Manual (Page 33)

electrolux installation instructions
33
Installation instructions
Warning: this appliance must be
earthed
If your appliance has been damaged in
transit, contact your supplier
immediately. Do not attempt to install
it.
Your appliance left the factory fully
packaged to protect it from damage. If
it is delivered without packaging and
damage has occurred, the
manufacturer cannot accept
responsibility. Contact your supplier for
advice.
Once the packaging has been
removed the appliance should only be
moved by hand. Do not use a sack
barrow or any other aid to lift the
appliance as damage may occur.
To move the appliance, open the
oven door and lift the appliance by
holding inside the top of the
compartment.
This is a type X appliance, which
means it is freestanding and can be
fitted with cabinets on one or both
sides.
Sidewalls, which are above hob level,
should be protected by heat resistant
non-combustible material and must
not be nearer than 40mm to the hob
side.
A nominal air gap of 2mm at either
side of the appliance is required to
enable the appliance to be moved into
position.
Always ensure an air gap is
maintained at hotplate level. Tiles or
other forms of deep wall covering
should not obscure this gap.
Overhanging surfaces or a cooker
hood should be a minimum of 685mm
above the hob.
It is important to ensure that the
appliance is level after installation.
Levelling feet are fitted to the appliance
to accommodate uneven floors.
Air gap