Grass Valley K2 Edge Installation v.4.1.0 - Manual (Page 50)

K2 Edge Installation and Service Manual - document version: 4.1 – Page 50
19.2 GPIO via the IP Manager
Define GPIO events via the IP Manager web interface to trigger events or templates on the K2Edge
when a GPI is coming in.
Example.
IP Manager web interface > Channel Configuration > GPIO

GPIO action: specify an action, for example GPI-5 switches to off
Use the pinning table to define conditionals for pins 1-8.

x: don't care (0 or 1)

0: low

1: high

Timecheat: check to enable cheat
type

None: results in no action

Script: runs a Linux shell script upon incoming GPIO commands, delayed by the configured delay
time if applicable.
Argument: script name preceded by the full path

Template: trigger a Composer template.
Argument: the template name which is configured in the channel pack

DB9M GPIO off: triggers a level on the specified GPIO bit, delayed by the configured delay
time if applicable.
Argument: GPI pin number

DB9M GPIO on: triggers a level on the specified GPIO bit, delayed by the configured delay time if
applicable.
Argument: GPI pin number

censor IO off: disables the censor on a SDI output port for the specified SDI port number
Argument: SDI port number (number only)