Grass Valley K2 Edge Installation v.4.1.0 - Manual (Page 28)

K2 Edge Installation and Service Manual - document version: 4.1 – Page 28
13.2 Replacing the front bezel
CAUTION: To avoid electrostatic discharge, make sure that you are properly grounded.
You do not have to halt or power off the K2 Edge when replacing a single power supply.
Hard disks are hot swappable and redundant.
WARNING: Any instructions in this manual that require opening the equipment cover or
enclosure are for use by qualified service personnel only. To reduce the risk of electric
shock, do not perform any servicing other than that contained in the operating
instructions unless you are qualified to do so.
 Unfasten the thumb screws from the unit.
 Carefully slide out the bezel and disconnect the display cable. Pull the display cable from
the connector and not from the wire. A small flat screw driver can be used to push the
connector’s tabs out.