Grass Valley 8950DAC - Manual (Page 19)

8950DAC Instruction Manual 19
Configuration
Local On-board Configuration Switches and LEDs
The 8950DAC module can be configured using the rotary and paddle
switches shown in
Figure 5 . The CONF and 2ND function LEDs are config-
uration status indicators. These four components perform the following:
• Function (rotary) switch — Addresses two banks of 16 possible posi-
tions (0 through 9 and A through F) to access a desired function for con-
figuration. Not all positions are used (see
Table 6 on page 20 ).
Note The Function switch should be kept in position 0 when not in use to avoid any
inadvertent change in configuration. 0 is an inactive position.
• SW2 (paddle) switch — Actuates or selects the desired setting for the
selected function when the switch is held momentarily in either the Up
or Down position.
• 2ND LED — When on, rotary switch is accessing the second bank of
configuration items.
• CONF (configuring) LED — When on, indicates the module is initial-
izing or processing configuration information.
Figure 5. Module Configuration Switches and LEDs
GRASS VALLEY GROUP 8 9 5 0 D A C 6 7 1 - 4 7 9 8 -
0604_05r1
J P 2
J P 2
L O C A L
R E M O T E
FUNCTION – rotary switch
SW2 – paddle switch
2nd – second function LED
CONF – configuration LED