Grass Valley 8920ADT User Manual
Page 23
8920ADT Instruction Manual
17
Configuration
Set the Operational Mode for the desired output of the module from the
thirteen selections listed below in
. After making the selection, click the Apply button
to activate it.
Gain adjustment of the module output levels can be done from this display.
Adjust the gain in either Sliders mode or Numeric mode (shown in
). The single arrows buttons increment or decrement the value
by 0.1 dB. The double arrow buttons will increment or decrement the value
by approximately 1.0 dB. These controls will allow you 0.0 to 20 dB range
of adjustment.
Note
In Numeric mode only, values selected with the single or double arrow keys
will be enabled immediately. All other display entries, including typed in
values, require pressing Apply before the selection is enabled.
Table 8. Remote Control Output Configuration Modes
Mode Name
Mode Description
Default
Factory default with no phase inversion, channel swapping or summing.
L/R Swap
Swaps left and right channel outputs.
L/R Invert
Both left and right channel outputs phase inverted.
L Invert
Left channel output phase inverted.
R Invert
Right channel output phase inverted.
R Mono (R to L/R)
Right channel to both channel outputs.
L Mono (L to L/R)
Left channel to both channel outputs.
L plus R to L/R
Left plus right to both channel outputs.
L minus R to L/R
Left minus right to both channel outputs
L plus R, L minus R
Left plus right to left channel output and left minus right to right channel output.
(L plus R) Inv to L/R Left plus right to both channel outputs with both channel outputs phase inverted.
AES Silence
AES silence on both left and right channel outputs.
1K@ -20dBFS
Tone to both channel outputs.