Grass Valley 8920ADT - Manual (Page 13)

8920ADT Instruction Manual 7
Power Up
Table 4. Indicator LEDs and Conditions Indicated
LED Indication Condition
FAULT
(red)
Off Normal operation.
On continuously Module has detected an internal fault.
Flashing Reference input is faulty or not present.
COMM
(yellow)
Off No activity on frame communication bus.
Long flash Location Command received by the module from a remote control system.
Short flash Activity present on the frame communication bus.
CONF
(yellow)
Off Module is in normal operating mode.
On continuously
Module is initializing, changing operating modes or updating firmware. Simulta-
neous CONF and FAULT LEDs on indicate FPGA load error.
Flashing Indicates rate of change of paddle-controlled analog setting.
PWR
(green)
Off No power to module or module’s DC/DC converter failed.
On continuously Normal operation, module is powered.
REM OVER
(yellow)
Off Module configuration matches switch and jumper settings.
On continuously
Module configuration may not match switch and jumper settings. Control has been
remotely overridden.
REF LOCK
(green)
Off Module does not detect a valid reference signal.
On continuously Valid reference signal is present and module is locked to it.
TRK ENABLE
(yellow)
This LED is currently not used. It will be on continuously.
TRACKING
(green)
Off Delay tracking input not present.
On continuously Delay tracking input present.
L >-20 DBFS
(green)
Off Left channel level is less than -20 dBFS.
On continuously Left channel level is greater than -20 dBFS.
Flashing Left channel level is transitioning through -20 dBFS
R >-20 DBFS
(green)
Off Right channel level is less than -20 dBFS.
On continuously Right channel level is greater than -20 dBFS.
Flashing Right channel level is transitioning through -20 dBFS
LEFT CLIP
(red)
Off Left channel digitized signal level is less than -0.5 dBFS.
On continuously Left channel digitized signal level is greater than -0.5 dBFS.
Flashing Left channel digitized signal level is transitioning through -0.5 dBFS.
RIGHT CLIP
(red)
Off Right channel digitized signal level is less than -0.5 dBFS.
On continuously Right channel digitized signal level is greater than -0.5 dBFS.
Flashing Right channel digitized signal level is transitioning through -0.5 dBFS.