Grass Valley 8920DAC - Manual (Page 13)

8920DAC Instruction Manual 7
Power Up
Table 3 provides the possible input and output conditions that result from
different inputs and settings.
Table 3. Possible Operating Conditions
Audio Input Condition Output Condition
Any AES-3id with sample rate between 32 kHz to 48 kHz
Audio will be converted at any sample rate between the minimum and maximum
rates. Sample rate LEDs will only light if rate is within 4% of any standard.
Any AES-3id with sample rate between 32 kHz to 48 kHz
with Function Switch is set to E (1 kHz Tone) 1 kHz tone with frequency of tone accurate only at 32 kHz, 44.1 kHz or 48 kHz
sample rates.
No AES-3id input
No sample rate LEDs will be lit, output will be muted, Fault LED flashing, signal to
noise level should be greater than or equal to maximum signal to noise level.
No AES-3id input with Function Switch is set to E (1 kHz Tone) No tone at output and output will be muted.