H3C Technologies H3C WA2110-AG Wireless LAN Access Point - Manual (Page 13)

7
Preparing Installation Tools
Prepare the following tools before installation:
•
Mounting bracket and screws that come with the device
•
Electric screwdriver and Phillips screwdriver
•
One electric drill and several auxiliary drill bits
Checking the Device Before Installation
Before mounting the WA2110-AG, connect it to the power adapter (if
applicable) and the Ethernet, and check the status of the LEDs to ensure
that the WA2110-AG can work properly. In addition, record the MAC
address of the access point for future use.
Attaching the Antennas
Attach the antennas accompanying the access point on to the antenna
connectors on the access point and hand-tighten them. After network
startup, you may need to adjust the antennas to fine-tune the coverage in
your area. For best results, adjust the antennas so that they are
perpendicular with the floor or ceiling.
CAUTION:
Do not handle the antenna tips, especially after they are connected to the
access point. This could lead to electrostatic discharge (ESD), which could
damage the equipment.
WARNING!
Do not touch or remove the access point when its antenna is receiving or
transmitting radio frequency signals.
Mounting the Access Point
The access point can be mounted on walls, ceilings, or tabletops.
Wall, ceiling mounting
To mount the access point to a wall or ceiling, follow these steps: