H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 15)

8
ACSEI configuration example (on WX6103)
Network requirements
The switch interface board of the WX6103 adopts OAA architecture and is installed on the slot with
purple paint at slot sides.
Enable ACSEI server on the main board and ACSEI client on the switch interface board.
Reboot the switch interface board acting as the ACSEI client, and then disable the ACSEI client.
Configuration procedure
1. Configure the main board:
# Enable ACSEI server.
system-view
[Sysname] acsei server enable
[Sysname] quit
# Access the CLI of the switch interface board from the main board.
oap connect slot 0
Press CTRL+K to quit.
Connected to OAP!
2. Configure the switch interface board:
# Enable ACSEI client on the interface connecting the switch interface board and the main board.
system-view
[Sysname-LSW] interface Ten-GigabitEthernet0/0/2
[Sysname-LSW-Ten-GigabitEthernet0/0/2] acsei-client enable
# Display the running status of the ACSEI client on the switch interface board.
[Sysname-LSW-Ten-GigabitEthernet0/0/2] display acsei-client status
Client ID: 1
Status: Open
Slot Number: 0
Interface: Ten-GigabitEthernet0/0/2
3. Configure the main board:
# Press Ctrl+K to return to the main board's CLI, and then reboot the ACSEI client.
system-view
[Sysname] acsei server
[Sysname-acsei server] acsei client reboot 1
Warning: The specified client will be rebooted. Continue? [Y/N]: y
# Disable the ACSEI client.
[Sysname-acsei server] acsei client close 1
Warning: The specified client will be closed. Continue? [Y/N]: y