H3C Technologies H3C MSR 50 - Manual (Page 21)

14
• Use the display ipx routing-table command to verify the static route takes effect, and to check
whether the next hop address is not specified or not correct on the non PPP interface.
Routes received from a neighbor router cannot be found by using the display ipx routing-table verbose
command
• Use the display current-configuration command to check whether the maximum dynamic route
number is configured on a per network ID basis, with the command ipx route max-reserve-path. If
it is not configured, the default value 4 is used.
• Use the display ipx routing-table verbose command to check whether the existing dynamic route
number under the destination network ID has reached the maximum number.
• If the upper limit is reached, the newly received routes will not be added to the routing table. You
can use the ipx route max-reserve-path command to adjust the maximum number of dynamic
routes.