H3C Technologies H3C SR6600-X - Manual (Page 96)

86
Table 42 SR6602-X2 panel LED description
LED Status Description
(yellow/green)
CF
Off
No CF card is in position or the CF card cannot be
recognized.
Steady green A CF card is in position and has been detected.
Flashing green
The system is accessing the CF card. In this state, do
not remove the CF card.
Steady yellow It is a non H3C CF card.
(red/green)
PWR1
Off The power module is not in position.
Steady green The power module is supplying power properly.
Steady red
No power is input or the power module is faulty
when PWR2 is operating properly.
(red/green)
PWR2
Off The power module is not in position.
Steady green The power module is supplying power properly.
Steady red
No power is input or the power module is faulty
when PWR1 is operating properly.
(red/green)
FAN
Off No power is input or the fan tray is not in position.
Steady green The fan tray is working properly.
Steady red The fan tray is faulty.
(red)
ALM
Off
The system is operating properly and there is no
alarm.
Steady red
A fault has occurred. In this state, check the system
log immediately.
(green)
RUN
Off The system is powered off or the router is faulty.
Flashing at 1 Hz The router operates properly as configured.
Flashing at 8 Hz
Software is being loaded or the router does not start
working yet.
(yellow/green)
LINK
Off The corresponding interface is not connected.
Steady green A 1000 Mbps link is present.
Steady yellow A 10/100 Mbps link is present.
ACT
Off No data is being received or transmitted.
Flashing yellow Data is being received or transmitted.
(yellow/green)
SFP+LINK/ACT
Off No link is present.
Steady green A 10 Gbps link is present.
Flashing green Data is being received or transmitted at 10 Gbps.
Steady yellow The transceiver module check is not passed.