Logging in to the router through telnet/ssh, Logging in to the router through the aux port – H3C Technologies H3C SR6600-X User Manual
Page 48
38
............................................................................
............................................................................
......Done!
System application is starting...
User interface con0 is available.
Press ENTER to get started.
Press Enter at the prompt and the prompt
Logging in to the router through Telnet/SSH
To log in to the router through Telnet/SSH:
1.
Log in to the router through the console port. Enable the Telnet or SSH function by using the telnet
server enable or ssh server enable command and set user privileges by using the user privilege
level command.
2.
Connect the PC to the interface on the router.
3.
Specify an IP address for an interface on the router.
NOTE:
For more information about how to log in to the router through Telnet, see
H3C SR6600 Router Series
Configuration Guides.
Logging in to the router through the AUX port
To log in to the router through the AUX port:
1.
After powering on the router, connect the console cable to the console port, and follow these steps
to configure the AUX port.
Step Command
1.
Enter system view
system-view
2.
Enter AUX user interface view
user-interface aux 0
3.
Set the authentication mode
authentication-mode none
4.
Set the user privilege level
user privilege level 3
2.
Connect the AUX port to the configuration terminal by using the console cable. Then you can log
in to the router through the AUX port.
NOTE:
For more information about how to log in to the router through the AUX port, see
H3C SR6600 Router
Series Fundamentals Configuration Guide.