H3C Technologies H3C SR8800 - Manual (Page 61)

54
[Sysname-Pos6/1/1/2:0] quit
2. Configure Router B:
# Configure the clock mode of interface E-CPOS 6/1/1.
system-view
[Sysname] controller E-Cpos 6/1/1
[Sysname-E-Cpos6/1/1] clock slave
# Create two 155 Mbps POS interfaces for E-CPOS 6/1/1.
[Sysname-E-Cpos6/1/1] oc-3 1
[Sysname-E-Cpos6/1/1-oc-3-1] using oc-3c
[Sysname-E-Cpos6/1/1-oc-3-1] quit
[Sysname-E-Cpos6/1/1] oc-3 2
[Sysname-E-Cpos6/1/1-oc-3-2] using oc-3c
[Sysname-E-Cpos6/1/1-oc-3-2] quit
[Sysname-E-Cpos6/1/1] quit
# Configure channelized interface POS 6/1/1/1:0.
[Sysname] interface Pos6/1/1/1:0
[Sysname-Pos6/1/1/1:0] ip address 10.110.4.2 255.255.255.0
[Sysname-Pos6/1/1/1:0] mtu 9100
[Sysname-Pos6/1/1/1:0] quit
# Configure channelized interface POS 6/1/1/2:0.
[Sysname] interface Pos6/1/1/2:0
[Sysname-Pos6/1/1/2:0] ip address 10.110.6.1 255.255.255.0
[Sysname-Pos6/1/1/2:0] mtu 9100
[Sysname-Pos6/1/1/2:0] quit
3. Configure Router C:
# Create a 155-Mbps POS channel on E-CPOS 6/1/1.
system-view
[Sysname] controller E-Cpos 6/1/1
[Sysname-E-Cpos6/1/1] using oc-3c
# Configure POS interface POS 6/1/1:0.
[Sysname]interface Pos6/1/1:0
[Sysname-Pos6/1/1:0] ip address 10.110.5.2 255.255.255.0
[Sysname-Pos6/1/1:0] mtu 9100
[Sysname-Pos6/1/1:0] quit
4. Configure Router D:
# Create a 155-Mbps POS channel on E-CPOS 6/1/1.
system-view
[Sysname] controller E-Cpos 6/1/1
[Sysname-E-Cpos6/1/1] using oc-3c
# Configure POS interface POS 6/1/1:0.
[Sysname] interface Pos6/1/1:0
[Sysname-Pos6/1/1:0] ip address 10.110.6.2 255.255.255.0
[Sysname-Pos6/1/1:0] mtu 9100
Use the display interface pos 6/1/1:0 command to check the connectivity status, and use the ping
command to check whether the network is reachable.