H3C Technologies H3C S5560 Series Switches - Manual (Page 6)

6
Figure 6 LSWM2XGT8PM installed
NOTE:
After an LSWM2XGT8PM interface card is installed, the switch is 55
mm (2.17 in) greater in depth.
Removing an interface card
CAUTION:
• Before you remove an interface card, remove the cable from it.
• After removing an interface card, if no new interface card is to be
installed, install the filler panel as soon as possible to prevent dust
and ensure good ventilation in the device.
Removing an LSWM2XGT2PM interface card
1. Prepare an anti-static bag.
2. Use the Phillips screwdriver to loosen the captive screw on the
interface card, as shown by callout 1 in
Figure 7 ,
3. Rotate outward the ejector lever as shown by callout 2 in Figure 7 .
4. Pull out the interface card slowly out the interface card slot as shown
by callout 3 in Figure 7 .
5. Place the removed interface card in the anti-static bag.