H3C Technologies H3C S5560 Series Switches - Manual (Page 3)

3
LEDs
Each 1/10GBase-T port on the LSWM2XGT2PM and LSWM2XGT8PM
interface cards has an LED to indicate its operating status.
Table 2 1/10GBase-T port LED descriptions
LED status Description
Steady green
The port is operating at 10 Gbps, and a link is
present on the port.
Flashing green The port is sending or receiving data at 10 Gbps.
Steady yellow
The port is operating at 1 Gbps, and a link is
present on the port.
Flashing yellow The port is sending or receiving data at 1 Gbps.
Off No link is present on the port.
NOTE:
The 1/10GBase-T port LEDs are not affected by the port mode
switching button on your switch. For more information about the port
mode switching button, see the installation guide of the switch.
Installing and removing an interface card
CAUTION:
• Before you install or remove an interface card, wear an ESD wrist
strap and make sure the strap makes good skin contact and is
reliably grounded.
• To avoid device damage, do not use excessive force when you
install or remove an interface card.
This example describes how to install and remove LSWM2XGT2PM and
LSWM2XGT8PM interface cards on an S5800-32C-EI switch.
Prepare the following tools before you install or remove an interface
card:
• Phillips screwdriver.
• Flat blade screwdriver.
• ESD wrist strap.