H3C Technologies H3C S5560 Series Switches - Manual (Page 8)

8
To remove an interface card:
1. Prepare an anti-static bag.
2. Use the Phillips screwdriver to loosen the captive screw on the
interface card, as shown by callout 1 in Figure 4 ,
3. Rotate outward the ejector lever as shown by callout 2 in Figure 4 .
4. Pull out the interface card slowly out the interface card slot as shown
by callout 3 in
Figure 4 .
5. Place the removed interface card in the anti-static bag.
Figure 4 Removing an LSWM2SP2PM interface card
Installing and removing SFP/SFP+ transceiver modules or
SFP+ DAC cables
For information about installing or removing SFP/SFP+ transceiver
modules or SFP+ DAC cables, see H3C Pluggable SFP[SFP+][XFP]
transceiver modules installation guide at www.h3c.com.
Verifying the installation
After the installation is complete, identify whether the interface card is
operating correctly according to the status of the SFP+ port LEDs.
If the interface card fails to operate correctly, perform the following steps:
1. Reinstall it following the installation procedures described in this
document.
2. If the problem persists, contact H3C Support.