H3C Technologies H3C S5560 Series Switches - Manual (Page 6)

6
Installing and removing an interface card
CAUTION:
• Before you install or remove an interface card, wear an ESD wrist
strap and make sure the wrist strap makes good skin contact and is
reliably grounded.
• To avoid device damage, do not use excessive force when you
install or remove an interface card.
This example describes how to install and remove an LSWM2SP2PM
interface card on an S5800-32C-EI switch.
Prepare the following tools before you install or remove an interface
card:
• Phillips screwdriver.
• Flat blade screwdriver.
• ESD wrist strap.
The installation tools are not provided with H3C devices. Prepare them
yourself.
Installing an interface card
To install an interface card:
1. Use the Phillips screwdriver to remove the screw on the filler panel in
the target interface card slot, as shown by callout 1 in
Figure 2 .
Keep the removed screw secure for future use.
2. Insert the flat blade screwdriver through the handle on the filler
panel to pull out the filler panel, as shown by callout 2 in
Figure 2 .
Keep the removed filler panel secure for future use.
3. Unpack the interface card.
4. Insert the interface card slowly into the slot along the guide rails, as
shown by callout 1 in
Figure 3 .
5. Rotate inward the ejector lever as shown by callout 2 in Figure 3
until the interface card is in close contact with the switch.
6. Use the Phillips screwdriver to tighten the captive screw on the
interface card, as shown by callout 3 in
Figure 3 .