H3C Technologies H3C S5560 Series Switches - Manual (Page 5)

5
NOTE:
H3C recommends that you use H3C SFP transceiver modules, SFP+
transceiver modules, or SFP+ DAC cables for the SFP+ ports on the
LSWM2SP2PM interface card. The SFP transceiver modules, SFP+
transceiver modules, and SFP+ DAC cables available for the
interface card are subject to change over time. For the most recent list
of SFP transceiver modules, SFP+ transceiver modules, and SFP+
DAC cables available for the interface card, contact H3C Support or
marketing staff.
For more information about H3C SFP transceiver modules, SFP+
transceiver modules, and SFP+ DAC cables, see H3C Transceiver
Modules User Guide at www.h3c.com.
LEDs
Table 6 describes LEDs for the SFP+ ports.
Table 6 SFP+ port LED descriptions
LED status Description
Steady green
A transceiver module is installed in the port. The
port is operating at 10 Gbps, and a link is present
on the port.
Flashing green The port is sending or receiving data at 10 Gbps.
Steady yellow
A transceiver module is installed in the port. The
port is operating at 1 Gbps, and a link is present
on the port.
Flashing yellow The port is sending or receiving data at 1 Gbps.
Off
No transceiver module is installed in the port, or
no link is present on the port.
NOTE:
The SFP+ port LEDs are not affected by the port mode switching button
on your switch. For more information about the port mode switching
button, see the installation guide of the switch.