H3C Technologies H3C S5800 Series Switches - Manual (Page 16)

11
Installing and Removing an Optional
Interface Card
NOTE:
•
This section takes the LSW1SP4P0 interface card and the H3C
S5820X-28C switch to illustrate the module installation and
removal.
• The installation tools are not shipped together with H3C’s
Ethernet switches. You need to prepare the tools.
The following tools are needed for installation and removal:
• Phillips screwdriver
• ESD-preventive wrist strap
Installing an Interface Card
1. Put on an ESD-preventive wrist strap and make sure that the strap
is in good contact with your skin and is properly grounded.
2. Loosen the mounting screws of the blank panel on the expansion
slot of the switch's front panel with a Phillips screwdriver and
remove the blank panel, as shown in
Figure 5 .