H3C Technologies H3C S12500 Series Switches - Manual (Page 7)

7
Figure 7 Removing an SFP+ transceiver module
Verifying the installation
Execute the display transceiver interface command on the device to
verify that the transceiver module/cable is installed correctly.
• If the transceiver module/cable information is displayed correctly,
the installation is correct.
In the following example, a QSFP+ cable is attached to FortyGigE
1/0/1:
[H3C] display transceiver interface FortyGigE 1/0/1
FortyGigE1/0/1 transceiver information:
Transceiver Type : STACK_QSFP_PLUS
Connector Type : COPPER
Wavelength(nm) : N/A
Transfer Distance(km) : 1(STACK)
Digital Diagnostic Monitoring : NO
Vendor Name : H3C