H3C Technologies H3C S12500 Series Switches - Manual (Page 4)

4
Installing/removing a QSFP+ DAC/AOC
cable
The installation and removal procedures are the same for QSFP+ DAC
cables and QSFP+ AOC cables. The following uses a QSFP+ DAC
cable as example:
To install a QSFP+ DAC cable:
1. Align the QSFP+ transceiver module (with the clasp on top) at one
end of the cable with the port in the chassis, as shown in
Figure 1 .
2. Horizontally and gently push in the module to fully seat it in the
port.
Figure 4 Installing a QSFP+ DAC cable
To remove a QSFP+ DAC cable:
1. Gently press and release the QSFP+ transceiver module.
2. Holding the cable, gently pull the clasp on the cable to pull out the
transceiver module.