H3C Technologies H3C S12500 Series Switches - Manual (Page 6)

6
CAUTION:
Do not touch the golden plating on an SFP+ module.
To install an SFP+ transceiver module:
1. Align the module with the SFP+ port, with the golden plating
facing the spring tab (see callout 1 in
Figure 6 ) in the SFP+ port.
If the chassis has two rows of ports, the spring tab in a port is on
the bottom in the upper row and on the top in the lower row.
2. Slightly press the module against the spring tab so you can push
the module straight into the port.
Figure 6 Installing an SFP+ transceiver module
To remove an SFP+ transceiver module:
1. Press the module with your thumb, as shown by callout 1 in Figure
7 .
2. Gently pull the clasp on the cable to pull out the transceiver
module, as shown by callout 2 in
Figure 7 .