Ensemble Designs BrightEye 70 HD/SD AES Embedder/Disembedder - Manual (Page 7)

BrightEye-7
Additionally, the VU indicator illuminates orange when the output is above 0 VU,
illuminates green when the output is above -20 VU, and doesn’t illuminate when
the output is below -20 VU. The Gain indicator illuminates red when the gain
level has been adjusted off from unity by the user. The 0 VU point corresponds in
the digital domain to the digital reference level (-18 or -20 dBFS.)
Pwr (Power)
Illuminates green when power is applied to the converter and the internal
voltage regulator is functioning correctly.
ADJUSTING PARAMETERS FROM THE FRONT PANEL
Use the Mode, Right Arrow, and Left Arrow buttons to select and adjust
parameters from the front panel.
Pressing the Mode button activates the front panel for editing and tabs between
each section of editable parameters.
Pressing the Right Arrow or Left Arrow advances the selection within a given
section of parameters, or increases (Right Arrow) or decreases (Left Arrow) the
value of a selected parameter.
The LED of an edited parameter will blink for 15 seconds, after which time its value is
stored in memory. If power is interrupted before this 15 second timeout period has
elapsed, the edited state will not be not saved.
The controls and their indicators are described below:
Mode
This control selects the Mux behavior with the following choices:
Mux – Embed audio into the SDI signal, replacing the existing embedded
content or cascading, augmenting the existing embedded content.
Demux – Disembed audio that is in the SDI signal.
NOTE :