Ensemble Designs BrightEye 70 HD/SD AES Embedder/Disembedder User Manual
Page 6
BrightEye 70 HD/SD AES Embedder/Disembedder
BrightEye-6
OPERATION
Control and operation of the BrightEye 70 is performed from the front panel or
with the BrightEye Control application.
Some control settings are only available with the BrightEye Control application. These
parameters cannot be monitored or controlled with the front panel.
Front Panel Controls and Indicators
The front panel of the converter, shown in the figure below, provides status indi-
cators and control over module setup.
Status Indicators
The following status indicators are provided on the front panel:
In
Illuminate green when a valid input is present on the SDI In connector.
Mode
The currently selected mode (Mux or Demux) is illuminated green.
Group
The AES group (1, 2, 3, or 4) currently targeted for embedding or disembedding
(depending on module configuration) illuminates green when the selected group
contains audio, and illuminates red when the selected group does not contain
audio.
Gain
These controls allow for quick adjustment of Gain level for the four channel pairs.
Gain adjustment is done in conjunction with the VU indicators. For independent
channel adjustment, and other controls, use the BrightEye Control application.
VU
VU output level and the status of the Gain adjustment for each of these channel
pairs is indicated by the state the VU and Gain indicators for each of the channel
pairs. The VU indicator illuminates red when the audio level exceeds the
headroom level set by the user (with the Peak Indicator control in
BrightEye PC or Mac).
BrightEye 70 Front Panel
NOTE
: