Ensemble Designs 9670 Audio Automatic Gain and Loudness Control and 9690 Audio Compliance and Monitoring Software - Manual (Page 16)

www.ensembledesigns.com
Avenue 9670 - page 16
LevelTrack™ Audio Loudness Control AGC Software Option
Out Bus Assignments
The mixer has 16 input channels and 16 output busses. Initially, each channel is assigned a separate
output bus. For example, by default, mixer input channel 1 is assigned to mixer output bus 1, indicated
by the green button in the Input Ch 1 control. However, you can assign multiple input channels to go
to the same output bus. Or you can have each input channel going to multiple output busses (from 0
to 16).
Input/Output Level Control
Each mixer channel has a level control on its input. There is not a separate output gain level control.
Configuring Audio Output
From the output of the mixer, you can send digital audio out through the 8 AES connectors. Analog
audio is output through the 15-pin D connector. The digital and analog audio paths may be used
simultaneously. You may also re-embed the audio.
Configuring Digital Audio Outputs
Use the Out Bus Assign controls from the Mix 1:4, Mix 5:8, Mix 9:12 and Mix 13:16 menus to route
mixer inputs to mixer outputs. For digital audio, mixer output pair 1/2 feeds SDI out 1/2 and/or AES out
1/2. Mixer output pair 3/4 feeds SDI out 3/4 and/or AES out 3/4, and so on.
Note: If an AES connector is selected as an input, it cannot simultaneously be used as an
output.