Ensemble Designs BrightEye 20 Analog and Digital Audio Embedder or Disembedder User Manual
Page 8

BrightEye 20 Analog and Digital Audio Embedder or Disembedder
BrightEye-8
Group Select
This control selects the AES group for disembedding with the following choices:
1 – AES Group 1
2 – AES Group 2
3 – AES Group 3
4 – AES Group 4
Ch 1/2 and Ch 3/4 VU Indicators
These indicators provide information about the level of the analog outputs on
these channels. More detailed indicators are available through the BrightEye
Control application.
Ch 1/2 and Ch 3/4 Gain Adjustment Indicators
These controls allow for quick adjustment of Gain level for these two channel
pairs. For independent channel adjustment, and other controls, use BrightEye PC
or Mac.
USING THE BRIGHTEYE CONTROL APPLICATION
The BrightEye PC and BrightEye Mac applications included on CD-ROM are
designed to allow you to configure and control the BrightEye 20 from a personal
computer. Installation and instructions for using this software application are
given in the PDF manual on disk.
If the BrightEye 20 is connected to a computer running this software, the
following menus are available for controlling and monitoring the unit.
Config Menu
•
Input Pres – indicates the presence of an SDI input. Shows: None, 525
Lock, or 625 Lock.
•
Mode – select device multiplexer mode. This pulldown lets you choose
between: Demux, Replace Mux, and Cascade Mux.
•
Group Status – indicates the status of the AES group selected for multi-
plexing. Shows group number and if there is valid audio in that group.
•
Group Sel – selects the AES group for multiplexing. This pulldown lets you
chose between: Group 1, Group 2, Group 3, or Group 4.
•
Audio In – selects the audio input for embedding. This control is disabled
when the device is in disembedding mode. This pulldown lets you select
between: AES, -10 dBu Analog, and +4 dBu Analog.