Rear connectors, Power connection, Usb connector – Ensemble Designs BrightEye 20 Analog and Digital Audio Embedder or Disembedder User Manual
Page 5: Aes 1/2 i/o and aes 3/4 i/o, Sdi out, Analog audio i/o, Sdi in

TM
BrightEye 20
BrightEye-5
REAR CONNECTORS
All connections to the BrightEye 20 are made on the rear of the unit. Refer to the
illustration below.
Power Connection
Connect a modular power supply to the 12 volt DC power input connection on the
far left of the unit. Use the locking ring to secure it.
USB Connector
The USB connector is used to provide more comprehensive control, diagnostics,
and upgrades to the unit from a PC or Mac. Use the BrightEye Control applica-
tion included on CD-ROM to make adjustments as described in the OPERATION
section of this user guide.
AES 1/2 I/O and AES 3/4 I/O
The AES 1/2 I/O and AES 3/4 I/O are BNC connectors that can function as either
digital audio inputs or outputs. Each connector can input or output an AES
stream (each containing 2 channels.)
SDI Out
The SDI Out is a BNC connector that outputs serial digital video. This output
conforms to the ITU-R 601 standard for serial digital video, with SMPTE 259M
serialization at 270 Mb/s.
Analog Audio I/O
Analog Audio I/O is a HD15 connector that function as an analog input or
output.
SDI In
The SDI In is a BNC connector that accepts a serial digital video input. This
input should conform to the ITU-R 601 standard for serial digital video, with
SMPTE 259M serialization at 270 Mb/s.
Analog Audio Pinouts
Signal
Pins
Input
Output
Aud 1 +, –, G
1, 2, 7
Input 1
Output 1
Aud 2 +, –, G
5, 4, 3
Input 2
Output 2
Aud 3 +, –, G
11, 12, 6
Input 3
Output 3
Aud 4 +, –, G
15, 14, 13
Input 4
Output 4
1
6
+
+
+
+
-
-
-
-
11
AUD 2
AUD 1
AUD 3
AUD 4
BrightEye 20 Rear Connectors