Ensemble Designs BrightEye 20 Analog and Digital Audio Embedder or Disembedder - Manual (Page 6)

BrightEye 20 Analog and Digital Audio Embedder or Disembedder
BrightEye-6
OPERATION
Control and operation of the BrightEye 20 is performed from the front panel or
with the BrightEye Control application.
Some control settings are only available with BrightEye PC or Mac. These parameters
cannot be monitored or controlled with the front panel.
Front Panel Controls and Indicators
The front panel of the converter, shown in the figure below, provides status indi-
cators and control over video input and output selection, and gain.
Status Indicators
The following status indicators are provided on the front panel:
In
Illuminate green when a valid input is present on the SDI In connector.
Mux
The currently selected Mux behavior (Demux, Replace, or Cascade) is illumi-
nated green.
Audio
The currently selected audio input source (AES, -10 dB Analog, or +4 dB
Analog) is illuminated green.
Group
The AES group (1, 2, 3, or 4) currently selected for disembedding and digital to
analog conversion illuminates green when the selected group contains audio, and
illuminates red when the selected group does not contain audio.
Ch 1/2 and Ch 3/4
VU output level and the status of the Gain adjustment for each of these channel
pairs is indicated by the state the VU and Gain indicators. The VU indicator illu-
minates red when the audio level exceeds the headroom level set by the user
(with the Peak Indicator control in BrightEye PC or Mac.) Additionally, the VU
indicator illuminates orange when the output is above 0 VU, illuminates green
when the output is above -20 VU, and doesn’t illuminate when the output is
BrightEye 20 Front Panel
NOTE :