Ensemble Designs 6020 Four Channel 24-bit Audio DAC - Manual (Page 15)

Avenue Touch Screen Remote Configuration
Avenue Touch Screen remote control menus for this module are illustrated and explained
below. Refer to the 6020 Parameter Table shown earlier for a summary of available
parameters that can be set remotely through the menus illustrated. For more information
on using Avenue Touch Screen, refer to the Avenue Touch Screen data pack that came with
the option.
6020 Avenue Touch Screen Menus
In the Ch 1 Menu shown below, set the following parameters:
• Ch 1/2 Mode - set the operating modes for Channels 1 and 2.
Choose from 2-Channel (Ch 1 and 2 will be independent), Stereo (Ch 1/2 will be a
stereo pair) or Quad Tracking (Ch 1-4 will track together.) Note that if you have
set Ch 3/4 to Quad Tracking or the Quad On function is enabled on the Quad
Menu, this selection will default to Quad Tracking.
• Ch 1 Digital Ref - set the Digital Audio Reference level to match the studio
reference (-20dBFS, -18dBFS or -16dBFS) for channel 1 (in 2-Channel mode),
Ch 1/2 if in Stereo mode or all four channels together if in Quad Tracking mode.
• Ch 1 Analog Ref - use slider to set the Analog Audio Reference level from -10dBu
to +8dBu (in 0.5dBu steps) for channel 1 only (in 2-Channel mode), Ch 1/2 if in
Stereo mode or all four channels if in Quad Tracking mode.
• Ch 1/2 Emph - sets the emphasis correction mode for these two channels. Off
disables the emphasis correction. On applies 50/15µS deemphasis to the two
channels when the sampling frequency is standard. (Note that deemphasis will not
be applied where frequencies are non-standard.) Auto applies 50/15µS deemphasis
as necessary depending on the AES input emphasis status and sampling frequency.
(Note that deemphasis will not be applied when the channel status indicates the
use of CCITT J.17 emphasis.)
Model 6020 Four Channel 20-bit Audio DAC
6020-15