Ensemble Designs 6020 Four Channel 24-bit Audio DAC - Manual (Page 14)

Refer to the Emph, Error, Nxt Error, Sampling Freq, Error Log, I/P AES, I/P
Emphasis, and Deemphasis indicator explanations for the Ch1/2 menu shown earlier.
The Quad Menu shown below has been provided to allow adjusting and monitoring all
four channels at the same time when in Quad Tracking mode. Set the parameters as
follows:
• Channel Mode - Click in the Quad On box to enable quad tracking simultaneous-
ly for all four channels. Note that Quad Tracking can also be enabled in any of
the previous Channel Mode menus.
• Emphasis Mode - set the emphasis mode for all four channels.
• Digital Ref - set all four channels for the Digital Reference level to match your
studio reference.
• Analog Ref - adjust the Analog Reference level of all four channels to
-10dBu to +8dBu (in 0.5dBu steps).
NOTE: Digital and Analog Ref settings and Emphasis Mode above will only be
active when Quad On is checked.
The following indicators are available in the menu below:
• Err 1/2 and Err 3/4 - indicates the presence of errors on the input signal pairs as
described previously in the Ch 1/2 Menu indicator descriptions.
• Emph (2 boxes) - each box shows the status of emphasis for the channel pair corre-
sponding to the Error box above it.
Model 6020 Four Channel 20-bit Audio DAC
6020-14