Ensemble Designs 5360 Four Channel Analog to Digital Video Converters and Embedders User Manual
Page 20

NOTE: The Config All menu as shown below is for model 5360. For the 5365, the Config
All menu contains only the Dig Ref Level field.
The Config All menu shown below allows you to select and monitor the reference for all
channels as follows:
•
Ref Source – select the external input reference. Available values are: Ext Ref,
Master Ref.
•
The status of the reference input will be displayed in the Reference read-only
window.
•
Dig Ref Level – set the digital reference output level for the audio output. Select
either -20 dBFS or -18 dBFS.
The Memory menu shown below allows you to save overall module setups to five memory
registers as follows:
•
Select Save, then one of the five memory registers Reg 1 – 5. The box will turn
green. The entire module setup is now saved in the selected register.
•
To recall a register, select the register box. If there is information saved, the box
will turn green. The saved setup will now be loaded to the module. Up to five
different module setups can be saved and recalled using the individual registers.
5360-20
Models 5360 and 5365 Four Channel Analog to Digital Video Converters and Embedders