Ensemble Designs 5470 Digital Processing Amplifier and Legalizer User Manual
Page 4
Model 5470 Digital Proc Amp and Model 5475 DNR
5470/5475-4
5475 SUBMODULE
Install the 5475 DNR submodule in the connector closest to the rear of the module labeled
J6). The submodule is keyed for proper insertion. Match the connector on the submodule
to the connectors on the top of the 5470 circuit board. Be sure to check pin alignment
before seating the submodule.
CABLING
Refer to the 3 RU and 1 RU backplane diagrams of the module below for cabling instruc-
tions. Note that unless stated otherwise, the 1 RU cabling explanations are identical to
those given in the 3 RU diagram.
Connect the processed signals
from Ser Out 1 – 4 BNCs to
601 destinations.
Connect the serial 601 input
signal to the Serial In BNC.
1 RU Backplane
Use the Loop Out BNC to
loop the reclocked serial input
signal to other destinations.
3 RU Backplane