Eneo VHM/ECLKA-W - Manual (Page 13)

3
b
a
b
a
b
(c)
(d)
Fig.
yoke
Fold-down-mechanism / housing disassembling
Housing back view
The rear housing cover is fastened to the middle section
by 3 Allen screws (M4) with seal (see fig. ).
The housing's lower support rail serves as guide.
Handle
II Opening the housing
To open the housing, undo the two screws (a) (see fig. )
located in the middle section. The housing body can now
be pulled off the middle section. The plug on the heater
cable on models with built-in screen heater will have to
be disconnected either at the screw terminal board or
the power supply unit, depending on model. An adapter
(yoke) provides a removable connection with the camera
tray. To obtain free access to installed components,
slide housing body to end of range. In a vertical position
(c), it can now be folded down and moved to the rear.
Alternatively, it can be removed from the remaining
housing completely (see fig. ) by pressing both yoke
arms together in a horizontal position (d).
Fig.