Eneo EDC-4222B - Manual (Page 15)

When the COMMUNICATION MODE is set to H/W
Dome camera address (ID) and Protocol can be used by selecting from the Hardware.
To prevent damage, each dome camera must have a unique address (ID). When installing
multiple dome cameras using a multiplexer, it is suggested that the dome camera address match
the multiplexer port number.
If you want to set the address more than 999, you should contact the service provider.
Example: Port 1 = Dome 1, Port 2 = Dome 2 … Port 16 = Dome 16. If more than 16 dome
cameras are installed using two or more multiplexers, ID of the dome camera should be ID of
MUX x No. of camera IN. (e.g. multiplexer ID= n, Camera IN= m then ID of Dome =16x
(n-1)+m )
Refer to Figures 10-11 for setting the dome camera address (ID) and protocol selection.
1
23 4
5
6
78 9
0
8
1
1
23 4
5
6
7 89
0
8
1
1
23 4
5
6
7 89
0
8
1
S3
S2
S1
S3 S2 S1 D OME ID
1 0 0 1
2 0 0 2
. . . .
9 9 9 999
Figure 10 – Setting Dome Camera Address (ID)
9