Eneo PLS-5304 - Manual (Page 14)

Part 1 – Introduction
14
Fen Setup
Run the INIT program on the local PC → Select the video
encoder → Click the Setup icon → Select IP Address
Setup → Set up the network connection information
and check the Set up FEN box → Click the Next button
→ Check the Use FEN box → Enter the FEN server
information.
• Use FEN: Enter the IP address or domain name of the
FEN server.
• Port: Select the port number of the FEN server.
• Use NAT: Check the box when the video encoder
uses a NAT (Network Address Translation) device for
network connection.
• FEN Name: Enter the video encoder name to be
registered on the FEN server. Check whether or not
the name is available by clicking the Check button.
• The video encoder supports FEN function. The
FEN function allows you to access the video
encoder remotely by using the FEN name instead
of its IP address and it allows the video encoder to
use dynamic IP addresses for remote connection.
For the FEN function to work properly, the video
encoder should be registered on the FEN server.
• You will need to get the IP address or domain
name and the port number of the FEN server from
your network administrator.
The FEN server that we support is for your
convenience and it can stop operating unexpectedly
for the server update or malfunction. We are not
responsible for any problems caused by the FEN
server stopping operation.